The roller brake tester can test and calculation each axis (left and right wheels) block force of the car, brake force and the deviation of brake force (process deviation, and maximum deviation), as well as the ratio of brake force and axis load, the ration of hand brake force and the whole quality of the car.
Maximum axle-load mass (kg)
Wheelbase (width/wide) (mm)
Braking force measurement range (kN)
Detection speed (km/h)
Drum diameter * length (mm)
Motor power (kW)
The power supply
Installation dimensions (mm)
The roller brake tester is used to measure the braking force of each axle (left and right wheels) of the inspected vehicle. It is mainly used to test the braking performance of the vehicle under the rated load-bearing mass. The roller brake tester can test and calculation each axis (left and right wheels) block force of the car, brake force and the deviation of brake force (process deviation, and maximum deviation), as well as the ratio of brake force and axis load, the ration of hand brake force and the whole quality of the car. As the foot brake pedal pressure gauge is installed, the brake pedal force and the brake coordination time can be detected, and around round business power curve and pedal force curve can be recorded and printed. The equipment is a core part of the motor vehicle security performance detection and the high technical performance requirements of safety testing equipment.
1. The main body is wholly welded, with high intension, no need to fix the main body on the ground with ground bolts and it is easy to adjust and install.
2. The rollers are covered with high-quality surface sand, advanced adhesives, and technology, the adhesion modulus is above 0.85 in case of both dry and wet, the longevity is over 200000 times. Test precision is high, repetition performance is good, brake force errors <1.5% (National standard <3%).
3.The reducer is manufactured by European technology, and the main parts of the motor, bearing, sensor, etc. are all domestic famous brand products, which have passed ISO9001 international quality system certification and CE certification
4. It can be equipped with high-quality sensors to form a brake tester with axle load, increase the items of testing the axle (wheel) load of the vehicle, which will reduce the floor area and save the investment that means no need to buy an axle(wheel) load tester.
5.You can choose the test bench with or without an airbag lifting device. (The airbag lifting device is for the convenience of the vehicle entering and leaving the tester)
6. With an automatic stop device, to prevent tire abrasion. We can provide two options: the third roller stop device and the software-controlled shutdown.